Zeramex Knowledge Base

Knowledge Base

Do you have any further questions? Go to the topic overview.

> To topic overview

How do I create a digital impression?

Digital impression

1. Clean the implant connection thoroughly. Place the appropriate scan body (SB, RB or WB) on the implant and ensure that the surface is clearly visible to the scanner when positioning (facing forward if possible). Tighten the scan body (SB, RB or WB) with the appropriate screw (max. 5 Ncm) and ensure that it is securely fastened.

2. Perform the scanning process according to the instructions for the system used. Send the digital scan data to the laboratory to create the 3D printed model with the corresponding analogue cavity.

Didn't find the answer to your question?

Leave a comment

Comments

No comments have been posted yet.